Sealed Shock Hardware

This sealed shock hardware is the ultimate for shock eyelet protection and life in adverse conditions. Shockcraft's own engineered sealing collars reach around the shock bushing to seal against the shock eyelet, keeping out contaminants to maximise pivot life.

Available only for rear shocks requiring 1/2" shock pins (Fox, New Manitou, New RS, etc). Sorry our sealing collars won't fit 12 mm shock eyelets found on X-fusion, Specialized AFR, older RS and older Manitou rear shocks.

3 Item(s)

per page

Set Descending Direction
  1. Shock pin length ranges, shown from left: 21.9 mm fully sealed, 30-35 mm with seals & collars, >35 mm with seals & collars (all include pre-tensioned IGUS bushing)

    Self-Install Sealed Straight Axle Shock Hardware (Shockcraft)

    $85.00

    Premium sealed 1/2" shock hardware for bikes that like to get wet and muddy

    Custom made to fit your shock eyelet and frame

    Includes stainless steel pin with Shockcraft's own sealing collars to keep contaminants out, and pre-tensioned IGUS bushing for best fit

    For pin lengths 25 mm and greater both sealing collars and spacers are used

    Allow 7 days lead time after order confirmation Learn More
  2. Fitted Sealed Straight Axle Shock Hardware (Shockcraft)

    Fitted Sealed Straight Axle Shock Hardware (Shockcraft)

    $95.00

    Premium sealed 1/2" shock hardware for bikes that like to get wet and muddy

    Custom fitted in our workshop to your shock's individual eyelet tolerances

    Includes stainless steel pin with Shockcraft's own sealing collars to keep contaminants out, and standard IGUS bushing

    For pin lengths 25 mm and greater both sealing collars and spacers are used

    Allow 7 days lead time after receipt of shock Learn More
  3. Two sets of Offset Hardware (included IGUS pre-tensioned bushing not shown)

    Offset Shock Hardware (Shockcraft)

    $90.00

    Heavy duty offset stainless steel shock pivot pin with two plastic collars and pre-tensioned IGUS bushing for best fit

    Custom made to fit your shock eyelet and frame

    This is shock hardware for one end of shock only

    Allow 7 days lead time after order confirmation

    Important: Check clearance between frame mounting tabs and shock body is sufficient to run offset hardware.  Also check suspension and tyre clearance throughout the stroke


    Learn More

3 Item(s)

per page

Set Descending Direction