You have no items in your shopping cart.
Available on backorder
ABS+ compression damper kit to upgrade Manitou 32 mm forks (Minute/Marvel/Machete/Drake/Circus/Tower).
Includes damper and machined aluminium knob with retainer screws.
Pro level with aluminium knobs and piston.
Fitment: M30 x 1.0 mm cap threads, 27.85-28.9 mm piston
Tune: ABS+ production XC stack (CV-11411-03). Fully tunable and re-valvable to fit any rider weight or terrain.
Shim kit and revalving instructions here.
Manitou Part Code: 141-26532-K013
Available on backorder
Final sizing and tolerancing of fork bushings to ensure minimal friction and maximum performance. Cures issue of friction and stiction to improve small bump control. Also reduces break-in time of a new fork to zero.
Burnish sizes are carefully chosen to provide maximum oil film thickness without any knocking or noticable play.
Available immediately for 30 mm, 32 mm, 34 mm, 35 mm and 36 mm forks. Other sizes will have a slight delay as we manufacture tooling.
Replacement or resizing of fork bushings to fix looseness, knocking or play. Includes burnishing to final size.
Available immediately for 28.6 mm, 30 mm, 32 mm, 34 mm, 35 mm, 36 mm and 40 mm forks. Other sizes will have a slight delay as we manufacture tooling.
Note wiper seals need removed for this service and almost always require replacement.
Shockcraft modified High Flow piston (rebound & mid valve) for Pro level forks with cartridge rebound
Fits Manitou Mattoc Pro, Magnum Pro, Mastodon Pro, Minute Pro, Machete Pro etc.
This piston greatly increases oil flow on sharp impacts and on very rough ground at speed, increasing reaction speed, removing high speed harshness and allowing more compression damping to be run
Blue aluminium with PTFE glide-ring 16 mm OD
Part Code: 126-27209HF
Exchange high flow pistons also available
Starting at: US$3.05
Additional 10mm travel spacers can be installed under Mastodon bottom-out bumpers to increase tyre (tire) clearance and reduce travel.
121-29113 spacer is smaller diameter used for top-out on Pro and Comp forks. Bottomout on air side of Pro forks.
121-30396 spacer is used for bottom-out on Comp fork damper side.
121-32318 spacer is used for bottom-out on Pro fork damper side and Comp fork air side.
Manitou Mattoc IRT Upgrade Kit 2020+
Adds a second air chamber for independent tuning of mid-end stroke.
Compatible with 2020+ Mattoc Pro, can be fitted to Comp with a piston swap.
Installs with a cassette tool and uses a flatter cap than earlier versions
Manitou part code: 141-32668-K010
Starting at: US$10.64
Upgrade your Mattoc Expert to Mattoc Pro specification.
Requires the Mattoc Pro rebound shaft assembly
Compression damping requires either the Mattoc Pro MC2 compression assembly or convert your Expert compression damper with the Pro HBO Cup.
27" wheel size for up to 160 mm travel
Manitou Part Codes: 141-30996-K017 (Rebound Assembly) & 141-30996-K001 (Compression Damper Assembly) or 126-30377 (Mattoc Pro HBO Cup)Learn More
A Shim Shuffle is changing the stock tune in a fork or shock damper to another factory pre-configured tune. For example changing a medium tune to a firm tune or a soft tune.
It is only available with a fork or shock service where factory tunes are published. It does not include any shims or parts, they are charged separately if required.
This charge is for shim shuffle as part of any compatible fork or shock service.