As with all Mezzer Pro’s, riders will enjoy the ultimate tunability of their air spring thanks to the pairing of our Dorado Air system and IRT (Infinite Rate Tune).  Dorado Air is derived from, you guessed it, Manitou's legendary Dorado inverted DH fork.  Using a unique balancing valve at the piston, the positive and negative air springs are equalized during the air fill process.  This design provides a smooth and consistent spring rate without any flat or dead spots that can be caused by a balance groove.  It also allows users to change the travel easily with the included travel spacers rather than purchasing expensive air springs.

Acting as a secondary positive air chamber the IRT provides complete control over the mid-late stroke of the fork.  This allows riders to tune their initial stroke separate from their mid-late allowing a butter-smooth initial feel without sacrificing mid-stroke support.  Being a compressible air chamber, rather than solid volume spacers, as you approach bottom out you are met with a feeling that is smooth and consistent rather than hash and abrupt.

The damping is taken care of through Manitou's fully sealed MC² cartridge damper.  Adjustments include external high and low-speed compression damping as well as low-speed rebound.  Manitou has also included a factory set HBO (hydraulic bottom out) to give riders an added level of control when things get gnarly.

Bleeder screws are also located on the back of the lower legs allowing riders to bleed air while on the trail using a 2.5 mm hex key.  These bleeder screws double as an oil injection port to give your seals a small blast of semi-bath oil in-between regular service intervals to keep things as smooth as possible at all times.

140-180 mm travel
110 x 15 mm boost axle
Tapered steerer tube
Bolt on mudguard fender
Fits 2.8" tyre without fender, 2.6" with.
Disc brake only (180+ mm post mount)
44 mm std offset only
574mm Axle-Crown measurement (180mm)
554mm Axle-Crown measurement (160mm)
534mm Axle-Crown measurement (140mm)
2000 g (4.4 lb)

Mezzer 29"

140-180 mm travel
110 x 15 mm boost axle
Tapered steerer tube
Bolt on mudguard fender
Fits 2.8" tyre without fender, 2.6" with.
Disc brake only (180+ mm post mount)
44 mm reduced offset only
594mm Axle-Crown measurement (180mm)
574mm Axle-Crown measurement (160mm)
554mm Axle-Crown measurement (140mm)
2032 g (4.4 lb)