Offset Shock Hardware (Shockcraft)

Availability: Custom made to order

SKU:CSAHSTDOFFSET

Heavy duty offset stainless steel shock pivot pin with two plastic collars and pre-tensioned IGUS bushing for best fit

Custom made to fit your shock eyelet and frame

This is shock hardware for one end of shock only

Allow 7 days lead time after order confirmation

Important: Check clearance between frame mounting tabs and shock body is sufficient to run offset hardware.  Also check suspension and tyre clearance throughout the stroke


$90.00

* Required Fields

$90.00
Description

Details

This Offset Straight Axle Shock Hardware is made with a stainless steel pin and two plastic collars.  Sealing collars are an optional extra.  An IGUS pre-tensioned bushing is included to ensure best fit.  The pre-tensioned bushing compensates for out of tolerance shock eyelets and wears longer before play becomes a problem.

Before purchase carefully check clearance between frame mounting tabs and shock body, as well as suspension and tyre clearance throughout the stroke, to ensure everything will clear when the offset hardware is fitted.

Sealing Collars: Shockcraft's own engineered sealing collars reach around the shock bushing to seal against the shock eyelet, keeping out contaminants to maximise pivot life.  Sealing collars are only available for pin lengths of 21.9 mm or >25 mm.  For 25 mm and greater pin lengths both sealing collars and plastic spacers are used.

Offset Limitations
Offsets available for 12.7 mm diameter pins: 2.3 mm with 6 mm bolt, 1.3 mm with 8 mm bolt
Offset available for 14 mm pins: 2.3 mm with 8 mm bolt

See below PDF for details on how to measure your Shock Pin Length/Diameter, Bolt Diameter and Shock Eyelet Width.


Note: 
If you have either an Ironhorse Sunday frame or Marzocchi Roco shock please contact us for pricing as these have special requirements for shock hardware.

Additional Information
Shock Hardware Measurement Guide: