This Offset Straight Axle Shock Hardware is made with a stainless steel pin and two plastic collars.  Sealing collars are an optional extra.  An IGUS pre-tensioned bushing is included to ensure best fit.  The pre-tensioned bushing compensates for out of tolerance shock eyelets and wears longer before play becomes a problem.

Before purchase carefully check clearance between frame mounting tabs and shock body, as well as suspension and tyre clearance throughout the stroke, to ensure everything will clear when the offset hardware is fitted.

Sealing Collars: Shockcraft's own engineered sealing collars reach around the shock bushing to seal against the shock eyelet, keeping out contaminants to maximise pivot life.  Sealing collars are only available for pin widths of 21.9 mm or >25 mm.  For 25 mm and greater pin widths both sealing collars and plastic spacers are used.

Offset Limitations
Offsets available for 12.7 mm diameter pins: 2.3 mm with 6 mm bolt, 1.3 mm with 8 mm bolt
Offset available for 14 mm pins: 2.3 mm with 8 mm bolt

See Additional Information for a PDF with details on how to measure your Shock Pin Width/Diameter, Bolt Diameter and Shock Eyelet Width.

Note: If you have either an Ironhorse Sunday frame or Marzocchi Roco shock please contact us for pricing as these have special requirements for shock hardware.