We are OPEN
Click here for updates on our current status.
 

Mounting Hardware

Set Descending Direction

9 Item(s)

  1. Premium sealed 1/2" shock hardware for bikes that like to get wet and muddy Custom fitted in our workshop to your shock's individual eyelet tolerances Includes stainless steel pin with Shockcraft's own sealing collars to keep contaminants out, and standard IGUS bushing For pin widths 25 mm and greater both sealing collars and spacers are used Allow 7 days lead time after receipt of shock Learn More
  2. Shock hardware custom fitted in our workshop to your shock's individual eyelet tolerances. Widths from ~16mm on up. Virtually any diameter and bolt hole possible. Includes stainless steel pin with plastic collars and standard IGUS bushing Allow 7 days lead time after receipt of shock Learn More
  3. Fits Manitou rear shocks with 1/2" ID eyelets (including McLeod, Radium, Revox & Swinger etc 2007 & later)
    21.8 mm total width
    6 mm bolt hole
    Two piece top-hat design

    Manitou Part Code: 142-27124-K003 Learn More
  4. Fits Manitou rear shocks with 1/2" ID eyelets (including McLeod, Radium, Revox & Swinger etc 2007 & later)
    22.2 mm total width
    6 mm bolt hole
    Two piece top-hat design

    Manitou Part Code: 142-27124-K005 Learn More
  5. Fits Manitou rear shocks with 1/2" ID eyelets (including McLeod, Radium, Revox & Swinger etc 2007 & later)
    21.8 mm total width 8 mm bolt hole
    Two piece top-hat design
    Manitou Part Code: 142-27125-K003 Learn More
  6. Fits Manitou rear shocks with 1/2" ID eyelets (including McLeod, Radium, Revox & Swinger etc 2007 & later)
    40 mm total width
    8 mm bolt hole
    Three piece pin and collar design

    Manitou Part Code: 142-27125-K047 Learn More
  7. Offset Shock Hardware - One End (Shockcraft)

    US$90.27

    Custom made to order

    Heavy duty offset stainless steel shock pivot pin with two plastic collars and pre-tensioned IGUS bushing for best fit

    Custom made to fit your shock eyelet and frame

    This is shock hardware for one end of shock only

    Allow 7 days lead time after order confirmation

    Important: Check clearance between frame mounting tabs and shock body is sufficient to run offset hardware.  Also check suspension and tyre clearance throughout the stroke


    Learn More
  8. Premium sealed 1/2" shock hardware for bikes that like to get wet and muddy Custom made to fit your shock eyelet and frame Includes stainless steel pin with Shockcraft's own sealing collars to keep contaminants out, and pre-tensioned IGUS bushing for best fit For pin widths 25 mm and greater both sealing collars and spacers are used Allow 7 days lead time after order confirmation Learn More
  9. Heavy duty stainless steel shock pivot pin with two plastic collars and pre-tensioned IGUS bushing for best fit Custom made to fit your shock eyelet and frame Allow 7 days lead time after order confirmation Learn More

Set Descending Direction

9 Item(s)