SKF seal head upgrade/replacement for RockShox charger 1 dampers
Fits Pike, Lyrik & Boxxer forks, both RC & RCT3 with Charger 1
Upgrade for early Pike forks built with Trelleborg seal head.
Replacement part for seal head on later model Pike, Lyrik & Boxxer forks

SRAM Part Code: 11.4015.353.030 Learn More

Final sizing and tolerancing of fork bushings to ensure minimal friction and maximum performance.  Cures issue of friction and stiction to improve small bump control.  Also reduces break-in time of a new fork to zero.
Burnish sizes are carefully chosen to provide maximum oil film thickness without any knocking or noticable play.

Available immediately for 30 mm, 32 mm, 34 mm, 35 mm and 36 mm forks.  Other sizes will have a slight delay as we manufacture tooling.

Learn More

Permanent repair of creaking and ticking noises from fork crowns.  Also improves fork stiffness.  Shockcraft has the technology and understanding to dismantle and reassemble fork crowns for safe and permanent creak repair.

Note that damaged crowns will be rejected.  This is not a repair for parts stretched or bent.

Pricing depends on whether we receive a stripped Crown Steerer Unit (CSU) only or a whole fork.  If you send a whole fork we need to strip and rebuild it.sembly. 
Forks with cartridge dampers (e.g. Fox FIT/GRIP/GRIP2/CTD, RockShox Charger, Manitou MC2 or Mezzer) require a minimum of a Lower Leg & Air Spring Service. 
Forks with in-leg or open bath dampers (e.g. Fox open bath, RockShox all except Charger, Marzocchi Z2) require a minimum of a Standard Service.  The service labour pricing provided excludes additional repair.  Parts, oil and freight are additional and vary depending on the brand & model and the problems found.

Available immediately for RS Zeb, RS Yari/Lyrik 35 mm, RS Pike 35 mm, RS 32 mm Fox 38 mm, Fox 36 mm, Fox 34 mm, Fox 32 mm Manitou 37, 34, 32 and 30 mm, MRP Ribbon 35mm  forks and more.  New sizes have a slight delay as we design and manufacture tooling.

Learn More

Replacement of individual Stanchion or Steerer Tubes in fork crowns.  Shockcraft has the technology and understanding to dismantle and reassemble fork crowns for repair.
Note that damaged crowns and tubes will be rejected. 

Shockcraft Part Code:  LBR-FORKTUBESWAP

Learn More

Vorsprung Luftkappe air piston with higher volume negative
Fits 2014-2017 RockShox Pike & Lyrik forks
Fits 2018+ Lyrik & Yari
Fits 2018+ Rockshox Pike with an A2 Adapter.
Not compatible with Debonair V2 or V3 shafts.
Requires 10 mm shaft clamp to install
Can be installed as part of any Shockcraft service (book here)

Learn More

Matrix Tune for RockShox Pike/Lyrik 2014-22 Charger 1, 2 & 2.1 forks and dampers

Internal tuning (revalving) for the RockShox Pike/Lyrik Charger 1, 2 & 2.1 dampers matched to your weight, terrain, bike geometry and riding style, combined with our Unharsh Modifications, to give you more comfort, control, traction and speed

We use our Fortune Teller to take weight, terrain, bike geometry and riding style and select your Matrix Tune from a rack pre-prepared tunes

Rockeater Tune
We also have our Rockeater Tune for the Pike/Lyrik Charger 1, 2 & 2.1, info here

Pricing
Send in either your whole fork or damper only
Matrix Tune pricing includes labour for tuning & service (damper only or whole fork), modifications and consumables, with optional wiper seals (SKF or OE RockShox)
Excludes repairs & repair parts and optional upgrades
Optional Air Spring/Coil upgrades (DebonAir V2/V3 and Vorsprung Luftkappe, Smashpot & Secus) shown
Service Pricing only (i.e. without tuning/modifications) is here

Want to buy a new tuned damper to bolt-in?
You can also purchase a brand new Pike or Lyrik Charger damper with Matrix or Rockeater Tune to bolt into your fork, see Related Products

Learn More

Rockeater Tune for RockShox Pike/Lyrik 2014-22 Charger 1, 2 & 2.1 forks and dampers
This is a preconfigured set of modifications and internal tuning which is targeted at 70-80 kg riders who like to ride rough stuff fast without getting beaten
They have enough range to also work great for riders from 60-90 kg
But even outside those limits they're better than anything you'll find factory

The Rockeater Tunes are based on our Matrix & Custom Tune series, incorporating Unharsh Modifications where needed.  But it's simpler.  There are no calculations or data needed.  Just send us either your fork or damper.  We will service, install and dyno test to make sure it's running perfectly.

As the Rockeater Tunes are a one-size-fits-all upgrade, they provide the same performance and improvements for any future owners, preserving your investment.

Matrix Tune
If you want the full experience of the Matrix Tune for the RockShox Pike/Lyrik Charger 1/2/2.1 we still do these too.  Information and pricing for the Pike/Lyrik Charger 1/2/2.1 Matrix Tune is here.

Pricing
Send in either your whole fork or damper only
Rockeater Tune pricing includes labour for tuning & service (damper only or whole fork), modifications and consumables, with optional wiper seals (SKF or OE RockShox)
Excludes repairs, repair parts and optional upgrades
Optional Air Spring/Coil upgrades (DebonAir V2/V3 and Vorsprung Luftkappe, Smashpot & Secus) shown
Service Pricing only (i.e. without tuning/modifications) is here

Want to buy a new tuned damper to bolt-in?
You can also purchase a brand new Pike or Lyrik Charger damper with Matrix or Rockeater Tune to bolt into your fork, see Related Products

Learn More

Rockeater Tune for RockShox Pike,Lyrik, Zeb & Boxxer 23+ Charger 3 forks and dampers
This is a preconfigured set of modifications and internal tuning which is targeted at 70-80 kg riders who like to ride rough stuff fast without getting beaten
They have enough range to also work great for riders from 60-90 kg
But even outside those limits they're better than anything you'll find factory

Stock the Charger 3 has a preloaded base-valve which causes spikes and harshness on all sharp impacts.  It also struggles on successive hits.  This Rockeater Tune includes a new Shockcraft Engineered damper piston which solves all the compression and check flow issues.

As the Rockeater Tunes are a one-size-fits-all upgrade, they provide the same performance and improvements for any future owners, preserving your investment.

Matrix Tune
Matrix tune isn't available for Charger 3 at this time.

Pricing
Send in either your whole fork or damper only
Rockeater Tune pricing includes labour for tuning & service (damper only or whole fork), modifications and consumables, with optional wiper seals (SKF or OE RockShox)
Excludes repairs, repair parts and optional upgrades
Optional Air Spring/Coil upgrades (DebonAir V2/V3 and Vorsprung Luftkappe, Smashpot & Secus) shown
Service Pricing only (i.e. without tuning/modifications) is here

Want to buy a new tuned damper to bolt-in?
You can also purchase a brand new Pike or Lyrik Charger damper with Matrix or Rockeater Tune to bolt into your fork, see Related Products

Learn More

Individual volume spacer for Rockshox 35mm forks (Pike, Lyrik, Yari etc) with solo air spring (no travel adjust).
SRAM Part Code (for pack of 10): 11.4018.032.001

Learn More

SKF Low Friction Flangeless Fork Seal kit for RockShox 35 mm forks Learn More

These are only available for Pike, other applications have been superseded by the Debonair C1 (V3).

Superseded by SRAM-LYRIKPIKEDEBONAIR-AIRSHAFTUPV3

Debonair name was used in Solo Air Lyrik and Yari forks in 2018.  We call this Debonair V1.
Debonair V2 was introduced for MY 2019.  It features shafts with higher negative air volume and lower friction than previous Solo-Air air spring shafts.  Visible differences are the red flat seal-head, plastic moulded grey or black piston and removable shaft foot.
This bigger negative volume and lower friction gives you better small bump response and lets you run more air pressure for more mid stroke support.  They are a bolt-in upgrade, but only fit solo-air forks.  Debonair V2 shafts are also available in different lengths if you want to change your fork travel.  Select the correct one for your forks.

These are available for self-install or can be installed as part of a Shockcraft service. Learn More

RockShox DebonAir V3 Seal Head Upgrade Kit (SRAM)

Contains a new seal-head and shaft foot to upgrade Debonair V2 (MY2019 or 2020)  to Debonair V3 (MY 2021)
This kit only works on Debonair 2 shafts, identified by a moulded plastic black or grey air piston (visible down the top of the stanchion).
It is not compatible with earlier Solo Air shafts or Debonair v1 (wich had a silver bolt visible in the top of the air piston).

Fits Pike, Revelation, Lyrik and Yari with Debonair V2 air shafts.

SRAM Part Code:  00.4020.573.000 Learn More

Debonair V3 (RS calls it Debonair C1) is a new design for mid 2020 release to make bikes ride higher in the travel and use travel more easily.
It is identified by a longer red shaft foot and a red base-plate which is hollow underneath.

These are available for self-install or can be installed as part of a Shockcraft service.  Sizes are specific to each model, generation and travel of fork.

All sizes ordered in from supplier upon customer order.  Usually available approx 2 days lead-time.

V3 are no longer available for Rockshox Pike A1-A2, use RockShox DebonAir V2 Air Shaft Upgrade (SRAM)

Learn More

Self contained Lyrik/Yari Charger 2.1 RC2 damper for repair or upgrade of RockShox Lyrik B1+ & Yari A1+ 2016+ forks
Fits 35 mm Lyrik 27/29, Yari 27/29 & Pike A2 29+ forks which use the Lyrik chassis
Adjustable 4 click High Speed Compression (HSC), 19 click Low Speed Compression (LSC) and Low Speed rebound (LSR)
580 mm overall length
For up to 180 mm travel
Includes adjuster knobs & foot bolt
Top cap threads 32 x 0.5 mm
Shipping dimensions:  75 x 75 x 630 mm
Charger 2.1 is a mid 2019 update with better damping circuits, lower friction and softer compression damping than Charger 2.0

SRAM Part Code: 00.4020.170.000

These dampers are ordered in from the NZ Supplier as required.  Lead time is usually 2 days.

Shockcraft can tune this damper for you before delivery.  This improves small bump compliance and support.  Important for hard and fast riders.

Learn More

Vorsprung Smashpot coil conversion system for Rockshox Lyrik and Yari forks
Fits Rockshox Lyrik and Yari, some Pike & Revelation forks with 35 mm stanchions and M32.5 x0.5mm top-caps (fine thread)
M32.5x1.0 (Coarse thread) kit for Non Boost Pike is available.
Includes adjustable hydraulic bottom-out system
Spring rates available from 30-80 lb/in.
Requires strip down, tools and oil to install
Can be installed as part of any Shockcraft service (book here)

Ordered in from NZ supplier upon customer order.  Usually available approx 2 days lead-time.

Learn More