You have no items in your shopping cart.
ABS+ damper kit for Manitou 32mm forks from 2008 to current.
Fully revalvable and tuneable compression damper assembly.
Red piston is 28mm OD (excluding oring) and fits the majority of Minute, Marvel, Machete and Circus forks.
Top cap threads M30x1mm
Manitou Part Code: 141-26532-K002
Available on backorder
Final sizing and tolerancing of fork bushings to ensure minimal friction and maximum performance. Cures issue of friction and stiction to improve small bump control. Also reduces break-in time of a new fork to zero.
Burnish sizes are carefully chosen to provide maximum oil film thickness without any knocking or noticable play.
Available immediately for 30 mm, 32 mm, 34 mm, 35 mm and 36 mm forks. Other sizes will have a slight delay as we manufacture tooling.
$30 as part of any fork service. $50 for legs alone without service.
Replacement or resizing of fork bushings to fix looseness, knocking or play. Includes burnishing to final size.
Available immediately for 28.6 mm, 30 mm, 32 mm, 34 mm, 35 mm, 36 mm and 40 mm forks. Other sizes will have a slight delay as we manufacture tooling.
$50 for one side with service. $70 for legs alone without fork service
$80 for both sides with service. $100 for legs alone without fork service.
Note wiper seals need removed for this service and almost always require replacement.
Shockcraft modified High Flow piston (rebound & mid valve) for Pro level forks with cartridge rebound
Fits Manitou Mattoc Pro, Magnum Pro, Mastodon Pro, Minute Pro, Machete Pro etc.
This piston greatly increases oil flow on sharp impacts and on very rough ground at speed, increasing reaction speed, removing high speed harshness and allowing more compression damping to be run
Blue aluminium with PTFE glide-ring 16 mm OD
Part Code: 126-27209HF
Exchange high flow pistons also available
Starting at: $5.00
Additional 10mm travel spacers can be installed under Mastodon bottom-out bumpers to increase tyre (tire) clearance and reduce travel.
121-29113 spacer is smaller diameter used for top-out on Pro and Comp forks. Bottomout on air side of Pro forks.
121-32318 spacer is used for bottom-out on Pro fork damper side and Comp fork air side.
121-30396 spacer is used for bottom-out on Comp fork damper side.
Starting at: $17.44
Upgrade your Mattoc Expert to Mattoc Pro specification.
Requires the Mattoc Pro rebound shaft assembly
Compression damping requires either the Mattoc Pro MC2 compression assembly or convert your Expert compression damper with the Pro HBO Cup.
27" wheel size for up to 160 mm travel
Manitou Part Codes: 141-30996-K017 (Rebound Assembly) & 141-30996-K001 (Compression Damper Assembly) or 126-30377 (Mattoc Pro HBO Cup)Learn More