You have no items in your shopping cart.
Smashpot Coil Conversion
Run over everything.
Presenting the Vorsprung Smashpot - a fork coil spring conversion system for single crown enduro forks, featuring externally adjustable hydraulic anti-bottoming technology to deliver precisely the amount of bottoming resistance you need. The benefits of coil are clear: if your first priority for your fork is outright performance and grip, get yourself a Smashpot.
Features:
• Catering to rider weights from 45 kg to 125 kg with 11 coil spring rates
• Allows lighter riders to get the most use out of their forks, and heavier riders the support they need without excessive air pressures
• Only coil conversion system on the market allowing 180 mm travel (note that 190 mm is not possible with the Zeb)
• Easily adjust your travel with internal spacers (note the minimum & maximum travel of your fork as determined by manufacturer)
• Unique Hydraulic Bottom-out System reduces harshness
• Can be transferred between different forks with minimal parts cost (a purchase of a new top cap or foot stud)
• Reliable and low maintenance, set and forget. User installable and serviceable
• Weight increase of approximately 250-450 g (dependent on spring rate and fork's existing spring system)
Why Coil?
Smooth & Consistent
Air springs have improved substantially over the years. Yeah, coils are heavier than air, and for some riders that alone is a dealbreaker - fair enough. The advantages of coil springs, however, are clear:
• Zero stiction or friction in a coil spring. And no moving seals in the spring system to wear out, cause friction or leak.
• Zero spring rate variation allowing more mid-stroke support and consistency.
• More oil in the fork - lubrication and service life are improved.
In short, improvements in sensitivity, grip, compliance, mid-stroke support and consistency, with reductions in harshness and hand pain.
Externally Adjustable Hydraulics
Bottom Out Resistance
Low weight aside, air springs outperform coil springs in one critical area: bottoming resistance. The hydraulic bottoming control valve addresses this with a speed sensitive shimmed valve which engages progressively and seamlessly in the last 50 mm of travel, bringing the fork to a smooth and controlled stop at the end of the travel. High energy and low energy inputs are effectively managed without harshness. Easy tool-free external adjustment ensures you get as much or as little bottoming resistance as you need at the turn of a dial. Increased stability as energy is dissipated, rather than stored and thrown back at you.
-
Smashpost Travel Adjust Kit (Vorsprung)
From: US$16.73
To: US$41.99
Travel adjust kit for Vorsprung Smashpot
Includes 10 mm top out travel spacers (x5, silver in picture) & spring travel spacers (2 x 2 mm, 1 x 10 mm, 2 x 20 mm black acetal spacers)
Required for changing travel if you do not have the original parts Learn More -
Smashpot Coil Conversion for DVO Onyx SC (Vorsprung)
From: US$300.36
To: US$374.36
Vorsprung Smashpot coil conversion system for DVO Onyx SC 2019+ forks
Learn More
Includes adjustable hydraulic bottom-out system
Spring rates available from 30-80 lb/in
Requires strip down, tools and oil to install
Can be installed as part of any Shockcraft service (book here) -
Smashpot Coil Conversion for Fox 36 2015+ (Vorsprung)
From: US$300.36
To: US$390.99
Vorsprung Smashpot coil conversion system for Fox 36 forks
Learn More
Fits 2015+ Fox 36 forks with M33x0.8mm top-caps
2021+ Fox 36 forks require the 20 mm top cap adapter
Includes adjustable hydraulic bottom-out system
Spring rates available from 30-80 lb/in
Will not fit E bike forks with smaller ID stanchions and caps
Requires strip down, tools and oil to install
Can be installed as part of any Shockcraft service (book here) -
Smashpot Coil Conversion for Fox 38 (Vorsprung)
From: US$308.58
To: US$382.58
Vorsprung Smashpot coil conversion system for Fox 38 mm 2021+ forks
Learn More
Includes adjustable hydraulic bottom-out system
Spring rates available from 30-80 lb/in
Will not fit E bike forks with smaller ID stanchions and caps
Requires strip down, tools and oil to install
Can be installed as part of any Shockcraft service (book here) -
Smashpot Coil Conversion for Marzocchi Z1 2019+ (Vorsprung)
From: US$300.36
To: US$374.36
Vorsprung Smashpot coil conversion system for Marzocchi Z1 forks
Learn More
Fits 2019+ Marzocchi Z1 forks with M33x0.8mm top-caps
Includes adjustable hydraulic bottom-out system
Spring rates available from 30-80 lb/in
Will not fit E bike forks with smaller ID stanchions and caps
Requires strip down, tools and oil to install
Can be installed as part of any Shockcraft service (book here) -
Smashpot Coil Conversion for Öhlins RXF36 (Vorsprung)
From: US$300.36
To: US$374.36
Vorsprung Smashpot coil conversion system for Öhlins RXF36 m.1 & m.2 forks
Learn More
Includes adjustable hydraulic bottom-out system
Spring rates available from 30-80 lb/in
Requires strip down, tools and oil to install
Can be installed as part of any Shockcraft service (book here) -
Smashpot Coil Conversion for RockShox Zeb (Vorsprung)
From: US$312.70
To: US$386.69
Vorsprung Smashpot coil conversion system for RockShox Zeb 2021+ forks
Learn More
Includes adjustable hydraulic bottom-out system
Spring rates available from 30-80 lb/in
Will not fit E bike forks with smaller ID stanchions and caps
Requires strip down, tools and oil to install
Can be installed as part of any Shockcraft service (book here) -
Smashpot Coil Conversion for RS 35 mm Pike, Lyrik, Yari etc (Vorsprung)
From: US$300.36
To: US$374.36
Vorsprung Smashpot coil conversion system for Rockshox Lyrik and Yari forks
Learn More
Fits Rockshox Lyrik and Yari, some Pike & Revelation forks with 35 mm stanchions and M32.5 x0.5mm top-caps (fine thread)
M32.5x1.0 (Coarse thread) kit for Non Boost Pike is available.
Includes adjustable hydraulic bottom-out system
Spring rates available from 30-80 lb/in.
Requires strip down, tools and oil to install
Can be installed as part of any Shockcraft service (book here) -
Smashpot Coil Springs (Vorsprung)
US$66.40Individual coil springs for the Vorsprung Smashpot coil conversion system.
Learn More
Spring rates available from 30-80 lb/in in 5 lb/in increments
Requires strip down, tools and oil to install
Can be installed as part of any Shockcraft service (book here)
We hold stock of springs from 35 to 50 lbs/in. Other spring rates are ordered in as needed. -
Smashpot Foot Stud Assembly for DVO Forks (Vorsprung)
US$70.83In stock
Replacement Smashpot foot stud assembly to fit DVO Onyx SC forks
Vorsprung Smashpot kits for RockShox, Fox, Öhlins & DVO use the same core assembly (inner & outer) with a different foot stud assembly & top cap
This foot stud assembly can be used to swap a Smashpot from a RockShox, Fox or Öhlins fork to a DVO Onyx SC fork
You will also need the Smashpot top cap for the DVO Onyx SC forks (see related products) Learn More -
Smashpot Foot Stud Assembly for Fox & Marzocchi Forks (Vorsprung)
US$70.83In stock
Replacement Smashpot foot stud assembly to fit Fox forks
Vorsprung Smashpot kits for RockShox, Fox, Öhlins & DVO use the same core assembly (inner & outer) with a different foot stud assembly & top cap
This foot stud assembly can be used to swap a Smashpot from a RockShox, Öhlins or DVO fork to a Fox fork
You will also need the Smashpot top cap for your specific Fox fork model (see related products) Learn More -
Smashpot Foot Stud Assembly for Öhlins Forks (Vorsprung)
US$70.83In stock
Replacement Smashpot foot stud assembly to fit Öhlins RFX36 forks
Vorsprung Smashpot kits for RockShox, Fox, Öhlins & DVO use the same core assembly (inner & outer) with a different foot stud assembly & top cap
This foot stud assembly can be used to swap a Smashpot from a RockShox, Fox or DVO fork to an Öhlins RFX36 fork
You will also need the Smashpot top cap for the Öhlins RFX36 forks (see related products) Learn More -
Smashpot Foot Stud Assembly for RockShox Forks (Vorsprung)
US$70.83In stock
Replacement Smashpot foot stud assembly to fit RockShox forks
Vorsprung Smashpot kits for RockShox, Fox, Öhlins & DVO use the same core assembly (inner & outer) with a different foot stud assembly & top cap
This foot stud assembly can be used to swap a Smashpot from a Fox, Öhlins or DVO fork to a RockShox fork
You will also need the Smashpot top cap for your specific RockShox fork model (see related products) Learn More -
Smashpot Top Cap (Vorpsprung)
From: US$25.26
To: US$37.60
Replacement Vorsprung Smashpot top caps
To swap a Smashpot to another fork you'll need the right top cap for the fork
If changing between fork brands you'll also need the appropriate foot stud (see related products) Learn More
Recent Posts
-
Shockcraft has a full range of Vorsprung Smashpot Coil Conversions in ... -
Bike of the Month June 2022 - Simon's Evil Calling with Tuned Fox 36 G... -
Shockcraft & Biken 15% Off Sale*, 24 Hours Only ...
Categories
Newsletter
Instagram