Debonair V3 (RS calls it Debonair C1) is a new design for mid 2020 release to make bikes ride higher in the travel and use travel more easily.
It is identified by a longer red shaft foot and a red base-plate which is hollow underneath.

These are available for self-install or can be installed as part of a Shockcraft service.  Sizes are specific to each model, generation and travel of fork.

All sizes ordered in from supplier upon customer order.  Usually available approx 2 days lead-time.

V3 are no longer available for Rockshox Pike A1-A2, use RockShox DebonAir V2 Air Shaft Upgrade (SRAM)

Learn More

Self contained Lyrik/Yari Charger 2.1 RC2 damper for repair or upgrade of RockShox Lyrik B1+ & Yari A1+ 2016+ forks
Fits 35 mm Lyrik 27/29, Yari 27/29 & Pike A2 29+ forks which use the Lyrik chassis
Adjustable 4 click High Speed Compression (HSC), 19 click Low Speed Compression (LSC) and Low Speed rebound (LSR)
580 mm overall length
For up to 180 mm travel
Includes adjuster knobs & foot bolt
Top cap threads 32 x 0.5 mm
Shipping dimensions:  75 x 75 x 630 mm
Charger 2.1 is a mid 2019 update with better damping circuits, lower friction and softer compression damping than Charger 2.0

SRAM Part Code: 00.4020.170.000

These dampers are ordered in from the NZ Supplier as required.  Lead time is usually 2 days.

Shockcraft can tune this damper for you before delivery.  This improves small bump compliance and support.  Important for hard and fast riders.

Learn More

Vorsprung Smashpot coil conversion system for Rockshox Lyrik and Yari forks
Fits Rockshox Lyrik and Yari, some Pike & Revelation forks with 35 mm stanchions and M32.5 x0.5mm top-caps (fine thread)
M32.5x1.0 (Coarse thread) kit for Non Boost Pike is available.
Includes adjustable hydraulic bottom-out system
Spring rates available from 30-80 lb/in.
Requires strip down, tools and oil to install
Can be installed as part of any Shockcraft service (book here)

Ordered in from NZ supplier upon customer order.  Usually available approx 2 days lead-time.

Learn More

Individual coil springs for the Vorsprung Smashpot coil conversion system
Includes heat shrink as pictured and spring isolator perch (also available separately here)
Spring rates available from 30-80 lb/in in 5 lb/in increments
Requires strip down, tools and oil to install
Can be installed as part of any Shockcraft service (book here)

All sizes ordered in from NZ supplier upon customer order.  Usually available approx 2 days lead-time.

Learn More