You have no items in your shopping cart.
Available on backorder
In Stock
1/2" H Type wiper seal - NBR Material
Dual lip type, wipes both ways.
Shockcraft Part Code: S-FWI-0.5x0.912x0.194-H-NBR
In Stock
5/8" H Type wiper seal - NBR Material
Dual lip type, wipes both ways.
Shockcraft Part Code: S-FWI-0.625x0.937x0.194-H-NBR
In Stock
AN 106 Wiper seal
1 1/6" shaft size
Shockcraft Part Code: S-FWI-1.06x1.33x1.07-AN
In Stock
Straight replacement for shock eyelets in Modern Manitou, Modern RS, Fox, 5th Element, Marzocchi & Stratos Rear Shock Eyelets 1/2" ID x 1/2" Wide.
Learn MoreIn Stock
Harder wearing upgrade for Modern Manitou, Modern RS, Fox, 5th Element, Marzocchi & Stratos Rear Shock Eyelets 1/2" ID x 1/2" Wide. Available with shock eyelet pressing or complete custom fitted shock hardware.
Learn MorePlease enquire
Flanged bushings for shock eyelets
Installed as a pair with o-rings (not included) for new fitment or repair
Straight replacement for similar bushings from Fox, Trelleborg etc
Note these have a tighter ID than Fox & IGUS
They can be reamed to size after installation if they are too tight
Out of stock
X-Fusion Flanged bushings for shock eyelets
Straight replacement for genuine Fox flanged bushings provided the pin isn't worn
Installed as a pair with o-rings (not included) for repair
If you have a worn pin causing a knock, then use the green versions which have a tighter ID
In Stock
Harder wearing upgrade for Modern Manitou, Modern RS, Fox, 5th Element, Marzocchi & Stratos Rear Shock Eyelets.
1/2" ID x 1/2" Wide.
Pre-tensioned bushing to accomodate small variations in eyelet diameter and shape without binding or play Available with shock eyelet pressing or complete custom shock hardware
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
Available on backorder
2 piece shock reducers to fit 12 mm ID shock eyelets (including early Manitou, X-Fusion, RockShox & Specialized AFR rear shocks)
Modern shocks usually use 12.7 mm (1/2") ID eyelets; our fitted & self-install 3 piece hardware is suitable for these shocks
Shock pin and collars to fit 12 mm ID shock eyelets (including early Manitou, X-Fusion, RockShox & Specialized AFR rear shocks)
Modern shocks usually use 12.7 mm (1/2") ID eyelets; our fitted & self-install hardware is suitable for these shocks
In Stock